Can
you perform a configuration sync?
Have you checked so that the BIG-IP devices are listening over the correct failover unicast address/port? Run the following command on both devices:
netstat -na | grep 1026
The output should look like this:
- [root@bigip02:Active:Changes Pending] log netstat -na | grep 1026
- udp 0 0 192.168.1.32:1026 0.0.0.0:*
- udp 0 0 10.10.10.32:1026 0.0.0.0:*
This setting is configured per device under: Device Management ›› Devices ›› [BIG-IP Hostname] ›› Failover Network.
No comments:
Post a Comment